Before we can install a power supply unit we need to prepare our case. Start off by taking the screws off the case. The cooler master centurium case has 2 screws holding the side panel. Take the screws off and slide open the side panel. If you look at the back of the case you will notice that there is a cut out. This cut out is made for ATX power supply units and therefore any brand of power supply will fit perfectly into place.
Put your case in horizontal position so its easier to work with. Take your power supply and slide it towards the back of the case so that the screw holes on power supply unit align with the holes on the case.
The PSU should fit nicely into place as shown on the image below.
Start putting the screws in using your fingers and then tighten it using a Phillips screw driver as shown. The screws should be supplied with your power supply unit, if not you can use the screws supplied with the case.
கருத்துரையிடுக Facebook Disqus